|
| |
E-MAIL US AT custsrv@chrissystems.com
THE FOLLOWING INFORMATION AND NOTE IN THE SUBJECT MATTER KOOL DRY
DRYER REGISTRATION
NAME
ADDRESS
CITY
STATE
ZIP
PURCHASED FROM
PURCHASE DATE
WARRANTY
Thank you for your purchase of a Kool Dry High Velocity Dryer. Chris Christensen Systems, the manufacturer, warrants the Kool Dry High Velocity Pet Dryers against defects in materials and workmanship arising under normal usage and care for a period of one year from date of original sale unless otherwise specified. (Note: Hose and all plastic hose attachments are not covered). If a problem occurs, please call for return instructions. Unit to be shipped freight prepaid to Chris Christensen Systems at P.O. Box 961, Fairfield, TX. 75840 USA.
WARRANTY DISCLAIMERS:
Damage in Shipment, rust or corrosion caused by detergent and/or moisture, dirty motors, failure that was caused by inadequate filter cleaning, damage caused by heavy impact, adapting any devices not approved or sold by manufacturer, evidence of disassembly or attempted field repair, any motor where
commentator or brush wear indicates the motor has been used to full extent of its normal life expectancy regardless of the date sold, are not warranted by Chris Christensen Systems.
Units returned for repairs found not be covered under warranty, manufacturer will notify owner of repair charges before repairing unit unless written instructions stating otherwise are included. All major credit cards are accepted.
MAINTENANCE INSTRUCTIONS
Your Kool Dry Dryer is equipped with two filter systems
1. CLEANING THE OUTSIDE INLET FILTER
This filter is on the outside front of the unit. It can be removed by pulling it out with your fingers and using the dryer to blow out any built up hair. Maintaining this filter will extend the time needed to clean the internal filter.
2. CLEANING THE INTERNAL FILTER
UNPLUG THE DRYER FROM THE ELECTRICAL OUTLET. This filter is located inside the box on the rear of the motor. Remove the two Phillips head screws from each side of the plastic case and slide the motor module from the case. Remove this filter (dome shape) and using the blower, remove the hair from both sides of the filter. Re-install the filter and secure using duct type. Make sure the wire nuts that hold the respective wires together have not come loose. Slide the motor module back into the case. Re-install the two Phillips screws on each side of the box. Maintaining this filter will help preserve the life of the motor. For motor brush replacements - please contact us at 800-654-7006.
AUTHORIZED KOOL DRY DRYER REPAIR STATIONS
Please note - For under warranty repair (within 1 year of purchase) your
dryer must be sent to the Manufacturer: Chris Christensen Systems, 124 Freestone
County Road 538 or P.O. Box 961, Fairfield, TX. 75840.
903-389-7949
For out of warranty repair you can contact any of the following Authorized
Kool Dry Dryer Repair Stations for your local convenience. ABC Mobile
Repair - 583 Le Harve, Lake Elsinor, CA. 92530 Tel: 866-609-1375 C&J
Sharpening - 3241 Shallford Rd., Atlanta, GA. 30341 Tel: 888-299-9275 Midwest
Grooming Supplies, 28686 W. Northwest Hwy., Lake Barrington, IL 60010 Tel:
800-558-0593 Whitman Sharpening, 510 Simons St., Coleman, MI 48618 Tel:
989-465-0000
|